The main objective of the present research is an experimental investigation of effect of particle size on hydrodynamics of an internally circulating fluidized bed (ICFB) with a draft tube. An ICFB (0.3 mx3.0 m) with a draft tube (0.1 mx0.6 m) is adopted to investigate the hydrodynamic characteristic of sand particles having wide range size distributions at cold bed test conditions. The particles with a moderately wide size distribution in the range of Geldart group B and Geldart group B-D nature are used in the experiments. U-tube manometer probes used to investigate the evolution of pressure drop across in the draft tube and the annular pressure drop. A complete pressure drop flow curves are established for wide range of static bed heights, draft tube gap height and gas superficial velocities. High speed camera was utilized to measure particle downward velocity in the annular moving bed region, which is useful to estimate solids recirculation rate in the ICFB. The pressure drop in ICFB's draft tube found increases with an increase with bed height and also increases with gap height between the draft tube bottom and air distributor. The pressure drop found sharply decreases with superficial gas velocity after the minimum spouting fluidization, and then a cross-over is observed in the pressure drop of annular bed compared to the draft tube. Solid Recirculation rate, Gs, slowly increases with the superficial velocity initially and then rapidly increases to larger values as the annular bed descents. Gs increases with bed height due to increased bed mass that causes the higher bed pressure drop. Geldart-B particles are having more pressure drop than the Geldart BD particles due to the maximum possible packing and high frictional resistance of the fine particles for the gas flow. Gas bypassing fraction increases with increased gap height and decreases with increased bed height. Gas bypassing fraction increases with increased mean particle size.